Chapter 16 Network Settings; Configure Tcp/Ip Settings; Device With Dual Network Interface - HIKVISION NVST HNR Series User Manual

Chapter 16 Network Settings

Configure TCP/IP Settings

Purpose
TCP/IP settings must be properly configured before you can operate the device will operate over a
network.

Device with Dual Network Interface

Go to System > Network > TCP/IP.
Select Net-Fault Tolerance or Multi-Address Mode under Working Mode.
 Net-Fault Tolerance: The two NIC cards use the same IP address, and you can select the main NIC
to LAN1 or LAN2. In this way, in case of one NIC card failure, the device will automatically enable
the other standby NIC card so as to ensure the normal running of the system.
 Multi-Address Mode: The parameters of the two NIC cards can be configured independently. You
can select LAN1 or LAN2 under Select NIC for parameter settings. Select one NIC card as the
default route. When the system connects with the extranet, the data will be forwarded through
the default route.
Configure other IP settings as needed.
Network Video Recorder User Manual
TCP/IP Settings
180