HIKVISION NVST HNR Series User Manual page 32

No. Name
9 PLAY Button
10 PREV Button
Troubleshooting Remote Control:
Make sure you have installed batteries properly in the remote control. And you have to aim the
remote control at the IR receiver on the front panel.
If there is no response after you press any button on the remote, follow the procedure below to
troubleshoot.
Go to Menu > Configuration > General > More Settings by operating the front control panel
or the mouse.
Check and remember the NVR No. The default NVR No. is 255. This number valid for all IR
remote controls.
Press the DEV button on the remote control.
Enter the NVR No. in step 2.
Press the ENTER button on the remote.
If the Status indicator on the front panel turns blue, the remote control is operating properly. If
the Status indicator does not turn blue and there is still no response from the remote, please
check the following:
Batteries are installed correctly and the polarities of the batteries are not reversed.
Batteries are fresh and not out of charge.
IR receiver is not obstructed.
If the remote still cannot function properly, please change the remote and try again, or contact the
device provider.
Network Video Recorder User Manual
Description
It is also used to auto scan in the PTZ Control menu.
Switch between single screen and multi-screen mode.
In PTZ Control mode, it is used to adjust the focus in conjunction with
the A/FOCUS+ button.
31