Configuring Nat - HIKVISION DS-7100NI-K1/W/M Series User Manual

Select Receivers
Select the receiver. Up to 3 receivers can be configured.
Receiver
The name of user to be notified.
Receiver's Address
The Email address of user to be notified.
Enable Attached Picture
Check Enable Attached Picture if you want to send email with attached alarm images. The
interval is the time of two adjacent alarm images. You can also set SMTP port and enable SSL
here.
Interval
The interval refers to the time between two actions of sending attached pictures.
6. Click Apply to save the email settings.
7. You can click Test to test whether your email settings work.

8.3.5 Configuring NAT

Two ways are provided for port mapping to realize the remote access via the cross-segment
network, UPnP™ and manual mapping.
Before You Start
If you want to enable the UPnP™ function of the device, you must enable the UPnP™ function of
the router to which your device is connected. When the network working mode of the device is
set as multi-address, the Default Route of the device should be in the same network segment as
that of the LAN IP address of the router.
UPnP™：Universal Plug and Play (UPnP™) can permit the device seamlessly discover the presence
of other network devices on the network and establish functional network services for data
sharing, communications, etc. You can use the UPnP™ function to enable the fast connection of
the device to the WAN via a router without port mapping.
Steps
1. Go to Menu → Configuration → Network → NAT.
Network Video Recorder User Manual
Figure 8-5 UPnP™ Settings
95