Configure Ports - HIKVISION NVST HNR Series User Manual

Table of Contents

Advertisement

 Each item should be corresponding with the device port, including server port, http port,
RTSP port and https port.
 The virtual server setting interface below is for reference only, it may be different due to
different router manufactures. Please contact the manufacture of router if you have any
problems with setting virtual server.

Configure Ports

You can configure different types of ports to enable relevant functions.
Go to System > Network > Advanced > More Settings and configure port settings as needed.
 Alarm Host IP/Port: With a remote alarm host configured, the device will send the alarm event or
exception message to the host when an alarm is triggered. The remote alarm host must have the
client management system (CMS) software installed.
The Alarm Host IP refers to the IP address of the remote PC on which the CMS software (e.g., CMS)
is installed, and the Alarm Host Port (7200 by default) must be the same as the alarm monitoring
port configured in the software.
 Server Port: Server port (8000 by default) should be configured for remote client software access
and its valid range is 2000 to 65535.
 HTTP Port: HTTP port (80 by default) should be configured for remote Web browser access.
 Multicast IP: Multicast can be configured to enable Live View for cameras that exceed the
maximum number allowed through network. A multicast IP address covers Class-D IP ranging from
224.0.0.0 to 239.255.255.255 and it is recommended to use an IP address ranging from
239.252.0.0 to 239.255.255.255.
When adding a device to the CMS software, the multicast address must be the same as that of the
device.
 RTSP Port: RTSP (Real Time Streaming Protocol) is a network control protocol designed to control
streaming media servers. The port is 554 by default.
 Enhanced SDK Service Port: The enhanced SDK service adopts TLS protocol over the SDK service
that provides safer data transmission. The port is 8443 by default.
Network Video Recorder User Manual
Setting Virtual Server Item
190

Advertisement

Table of Contents
loading

Table of Contents