Menu In On-Line Mode - GCC Technologies P3-60 User Manual

3.2

Menu in On-line Mode

Power On
Puma III in processing
GCC Cutter
LCM Version- - -
Puma III
Firmware: Copyright:
Place Media And Then Lower
Down The Lever
Roll Edge Single
Sizing Media Width Lever Up
To Abort
Sizing Media Length Lever Up
To Abort
Top menu
S--- F----- O----
L-------- W-----T1M
Sending data
[PAUSE ]
The Control Panel
use to select
Pause Setup Resume
[ FORCE]
[ SPEED ]
[ OFFSET ]
[ DATA CLEAR ]
[TOOL SELECT ]
Force:80 gf
OK:ENTER
Offset: 0.275 mm
OK:ENTER
Clear Data Memory
N:Cancel OK:ENTER
1S:51 F:80 O:0.275 M
Select: OK:ENTER
Set Smoothing Cut
Select: OK:ENTER
OverCut: 0.00mm
Select: OK:ENTER
Set Tangential Mode
Select: OK:ENTER
3-2
Puma III User Manual
use to select; [ENTER] to enable the setting
Speed: 51cm/s
Select: OK:ENTER
UP Speed: 51 cm/s
Select: OK:ENTER
Quality: Fine
Select: OK:ENTER