Menu In On-Line Mode - GCC Technologies Jaguar V Series User Manual

3.2

Menu in On-line Mode

Power On
Jaguar V in processing
Cutter
LCM Version- - -
Jaguar V
Firmware: Copyright:
Place Media And Then
Lower Down The Lever
Roll Edge Single
Key Key Key
Sizing Media Width
Lever Up To Abort
Sizing Media Length
Lever Up To Abort
拨杆
Top menu
S--- F----- O----
L-------- W-----T1M
Sending data
[PAUSE]
The Control Panel
use to select
Pause Setup Resume
[FORCE]
[SPEED]
key ]
[OFFSET]
[DATA CLEAR]
[TOOL SELECT]
Force:80 gf
OK:ENTER
Offset: 0.275 mm
OK:ENTER
Clear Data Memory
N:ONLINE OK:ENTER
1S:72 F:80 O:0.275 M
Select: OK:ENTER
Set Smoothing Cut
Select: OK:ENTER
OverCut: 0.00mm
Select: OK:ENTER
Set Tangential Mode
Select: OK:ENTER
Pouncing 0 mm
Select: OK:ENTER
3-2
Jaguar V User Manual
Please see details in "3.4 Menu Items"
use to select; [ENTER] to enable the setting
，按[ 确认 ]保存
Speed:
Select: OK: ENTER
Quality:
Select: OK: ENTER
Up Accel.:
Select: OK: ENTER
UP Speed:
Select: OK: ENTER
72 cm/s
Normal
Medium
72 cm/s