12
TECHNICAL DATA
12
Technical data
12.1
Data sheet
54
O P E R A T I N G I N S T R U C T I O N S | deTec4 Core Vibes
Table 8: General system data
Protective field height, depending on
type
Resolution (detection capability)
Sensing sensing range, type-specific
Receiver with low sensing range
Receiver with medium sensing
range
Receiver with high sensing range
Minimum distance between sender and receiver
Receiver with low sensing range
Receiver with medium sensing
range
Receiver with high sensing range
Protection class
2)
Enclosure rating
Supply voltage U
at the device
V
Residual ripple
5)
Synchronization
Type
Category
Performance level
6)
Safety integrity level
6)
SIL claim limit
6)
PFHd (mean probability of a danger‐
ous failure per hour)
T
(mission time)
M
Safe state when a fault occurs
Power-up delay of sender and
receiver after supply voltage is
applied
1)
If the protective fields are very wide, there is a possibility that all four alignment quality LEDs will not light
up even when alignment is good.
2)
SELV/PELV safety/protective extra-low voltage.
3)
The external voltage supply must jumper a brief power failure of 20 ms as specified in IEC 60204-1. Suit‐
able power supply units are available as accessories from SICK.
4)
A fuse rated maximum 2 A shall be installed in the isolated 24 V DC power supply circuit to the device in
order to limit the available current.
5)
Within the limits of U
.
V
6)
For more detailed information on the exact configuration of your machine, please consult your respective
SICK subsidiary.
Minimum
Typical
300 mm to 2,100 mm, 150-mm steps
30 mm
1)
3.8 m
6 m
12 m
15 m
1.8 m
3.8 m
0 m
III (IEC 61140)
IP65 (IEC 60529)
IP67 (IEC 60529)
19.2 V
24 V
3) 4)
Optical
Type 4 (IEC 61496-1)
Category 4 (ISO 13849-1)
PL e (ISO 13849-1)
SIL3 (IEC 61508)
SILCL3 (IEC 62061)
3.7 × 10
-9
20 years (ISO 13849-1)
At least one OSSD is in the OFF state.
Maximum
28.8 V
± 10%
2 s
8024467/2019-06-18 | SICK
Subject to change without notice
Need help?
Do you have a question about the deTec4 Core Vibes and is the answer not in the manual?
Questions and answers