Troubleshooting; Safety; Diagnostic Leds; Fault Indicators - SICK deTec4 Core Vibes Operating Instructions Manual

10

TROUBLESHOOTING

10 Troubleshooting
10.1

Safety

10.2

Diagnostic LEDs

10.2.1

Fault indicators

50 O P E R A T I N G I N S T R U C T I O N S | deTec4 Core Vibes
DANGER
Hazard due to lack of effectiveness of the protective device
Persons and parts of the body to be protected may not be recognized in case of non-
observance.
Immediately shut the machine down if the behavior of the machine cannot be
b
clearly identified.
Immediately put the machine out of operation if you cannot clearly identify or allo‐
b
cate the fault and if you cannot safely remedy the fault.
Secure the machine so that it cannot switch on unintentionally.
b
DANGER
Hazard due to unexpected starting of the machine
When any work is taking place, use the protective device to secure the machine or
b
to ensure that the machine is not switched on unintentionally.
DANGER
Hazard due to lack of effectiveness of the protective device
Persons and parts of the body to be protected may not be recognized in case of non-
observance.
Do not do repair work on device components.
b
Do not make changes to or manipulate device components.
b
Apart from the procedures described in this document, the device components
b
must not be opened.
NOTE
Additional information on troubleshooting can be found at the responsible SICK sub‐
sidiary.
Overview
In the event of a fault, the type of fault is indicated by the LED display on the sender or
receiver.
Sender
Position of LEDs: see "Sender indicators", page 13.
8024467/2019-06-18 | SICK
Subject to change without notice