KidKraft ASHBERRY Installation And Operating Instructions Manual page 56

Step 21: Lower Swing Wall Assembly
A: Tight to the top of (2157) Ground SW Side and flush to the outside edges of both (2153) Posts on the
Swing Wall side attach 4 (2116) Siding to each post with 2 (S0) #8 x 7/8" Truss Screws per board, as shown in
fig. 21.1 and 21.2. Make sure there are no gaps between boards.
B: Tight to the top (2116) Siding and flush to outside edges of both (2153) Posts attach (2155) Siding Narrow
to each post with 2 (S0) #8 x 7/8" Truss Screws as shown in fig. 21.3.
C: Place (2144) Lower Bench tight to the top of (2155) Siding Narrow and flush to the outside edges of both
(2153) Posts then attach to posts with 4 (S7) #12 x 2" Pan Screws (with flat washer). (fig. 21.3)
D: From inside the assembly place (2139) SW Wall Support over the centre pilot holes of the (2116) Siding
and (2155) Siding Narrow and flush to the top of (2144) Lower Bench then attach from outside of the assembly
with 1 (S0) #8 x 7/8" Truss Screw per siding and 1 (S1) #8 x 1-1/8" Wood Screw in (2157) Ground SW Side.
(fig. 21.2 and 21.3)
Fig. 21.2
3/16" flat
washer
S0
x 3 per board
Wood Parts
1 x Lower Bench 1 x 4 x 38-7/8"
2144
1 x Siding Narrow 3/8 x 3 x 38-3/4"
2155
4 x Siding 3/8 x 3-1/2 x 38-3/4"
2116
1 x SW Wall Support 5/4 x 2 x 23-1/2"
2139
Inside View
2153
S7
x 4
S1
2139
Swing Wall
Outside View
2139
(hidden)
2144
Hardware
4 x #12 x 2" Pan Screw (3/16" flat washer)
S7
15 x #8 x 7/8" Truss Screw
S0
2 x #8 x 1-1/8" Wood Screw
S1
56
Fig. 21.1
2155
Fig. 21.3
2153
2116
2157