KidKraft ASHBERRY Installation And Operating Instructions Manual page 57

Step 22: Attach Access Ladder/Rockwall Assembly to Fort
Pre-drill all holes using a 3/16" drill bit before
installing the Lag Screws
A: Remove (2149) Top Bottom Rockwall from the top
of the Access Ladder Rockwall, previously assembled
in Step 2. Set the board and screws aside, they will
be re-attached. (fig. 22.1 and 22.2)
B: Place the Access Ladder Rockwall in opening
on the Back Wall, attach to (2123) Back Floor with
1 (H12) 1/4 x 3" Hex Bolt (with lock washer and flat
washer, t-nut previously installed) in both (2101)
Access Ladder Left and (2117) Rock Rail and then 1
(LS3) 1/4 x 3" Lag Screw (with flat washer) in (2100)
Access Rail Right. (fig. 22.1 and 22.2)
C: Re-attach (2149) Top Bottom Rockwall to the
same place it was removed. Notice screw holes are
towards the bottom of the board. (fig. 22.3)
D: Attach (2157) Ground SW Side to (2100) Access
Rail Right with 2 (S15) #8 x 1-3/4" Wood Screws.
(fig. 22.4)
Fig. 22.3
2149
Fig. 22.2
2123
H12
(T-nuts previously
installed)
Note hole
orientation
2117
1/4" lock
washer
2101
Hardware
LS3
1 x 1/4 x 3" Lag Screw (1/4"flat washer)
2 x 1/4 x 3" Hex Bolt (1/4" lock washer, 1/4"flat washer, t-nuts previously installed)
H12
2 x #8 x 1-3/4" Wood Screw
S15
57
Fig. 22.1
Back Wall
2100
1/4" flat
LS3
washer
1/4" flat
washer
Fig. 22.4
2157
S15
Flush
2100