KidKraft ASHBERRY Installation And Operating Instructions Manual page 36

Step 10: Back Wall Assembly
Part 1
A: Attach 2-1/4" t-nuts to centre bolt holes in (2123) Back Floor prior to attaching to posts. When attaching the
posts make sure the T-nuts are in between the (2120) Floor Front Back and the (2123) Back Floor. (fig. 10.1 and
10.2)
B: Loosely attach 2 (2153) Posts to (2150) Front Back Ground with 4 (H2) 1/4 x 2" Hex Bolts (with lock washer,
flat washer and t-nut) and to (2145) Back Top with 2 (H2) 1/4 x 2" Hex Bolts (with lock washer, flat washer and
t-nut), as shown in fig. 10.1.
C: With a helper loosely attach (2123) Back Floor on the outside of the assembly and (2120) Floor Front Back
on the inside of the assemby to both (2153) Posts with 2 (H15) 1/4 x 3-3/4" Hex Bolts (with lock washer, flat
washer and t-nut). (fig. 10.1)
Fig. 10.2
2120
1/4" t-nuts
Note the t-nuts
are on the inside
of the board.
Back View
Wood Parts
1 x Floor Front Back 2 x 3 x 64-1/4"
2120
1 x Back Floor 5/4 x 4 x 67"
2123
1 x Front Back Ground 1 x 5 x 67"
2150
1 x Back Top 1 x 4 x 52"
2145
2 x Post 2 x 4 x 96-1/2"
2153
2123
1/4" t-nut
1/4" flat
washer
1/4" lock
washer
1/4" t-nut
1/4" flat 1/4" lock
washer washer
Hardware
6 x 1/4 x 2" Hex Bolt
H2
(1/4" lock washer, 1/4" flat washer, 1/4" t-nut)
2 x 1/4 x 3-3/4" Hex Bolt
H15
(1/4" lock washer, 1/4" flat washer, 1/4" t-nut)
2 x 1/4" t-nuts
36
2145
2120
2153
2123
2150
Fig. 10.1
H2
2153
Notice hole locations
H15
H2
Front View