KidKraft ASHBERRY Installation And Operating Instructions Manual page 38

Step 11: Swing Wall Assembly
Part 1
A: With at least one adult helper hold up the Front and Back Walls and loosely attach (2157) Ground SW Side
using 4 (H4) 1/4 x 4" Hex Bolts (with lock washer, flat washer and t-nut), (2126) SW Floor using 2 (H5) 1/4 x
4-1/2" Hex Bolts (with lock washer, flat washer and t-nut) in the top holes and (2106) SW Top using 4 (H5) 1/4 x
4-1/2" Hex Bolts (with lock washer, flat washer and t-nut) to both (2153) Posts. (fig. 11.1)
B: Loosely attach (2130) SW Mount to (2126) SW Floor and to (2106) SW Top with 2 (G5) 5/16 x 4-1/2" Hex
Bolts (with lock washer, flat washer and t-nut). Keep these bolts loose until Step 13, Part 1. (fig. 11.1)
Note: Pre-drill all holes using a 1/8" drill bit before installing the lag screws.
C: Make sure the assembly is square then tighten all 1/4" Hex Bolts from this step. Attach (2126) SW Floor to
each (2153) Post with 2 (LS3) 1/4 x 3" Lag Screw (with flat washer). (fig. 11.1)
5/16" flat
washer
1/4" flat
washer
1/4" lock
washer
Wood Parts
1 x SW Top 5/4 x 5 x 38-3/4"
2106
1 x SW Mount 2 x 4 x 34-1/2"
2130
1 x SW Floor 5/4 x 5 x 38-3/4"
2126
1 x Ground SW Side 1 x 5 x 81-1/8"
2157
2153
Fig. 11.1
2106
H5
x 4
G5
H5
LS3
5/16" lock
washer
G5
H4
G5
2 x
H4
4 x
6 x H5
2 x
LS3
Back Wall
5/16"
t-nut
2126
H5
LS3
1/4"
t-nut
2157
Hardware
5/16 x 4-1/2" Hex Bolt (5/16" lock washer, 5/16" flat washer, 5/16" t-nut)
1/4 x 4" Hex Bolt (1/4" lock washer, 1/4" flat washer, 1/4" t-nut)
1/4 x 4-1/2" Hex Bolt (1/4" lock washer, 1/4" flat washer, 1/4" t-nut)
1/4 x 3" Lag Screw (1/4" flat washer)
38
Notice holes towards top.
2153
2130
Notice pilot holes are
above bolt hole (not
shown in picture)
1/4" flat
washer
Front Wall