KidKraft ASHBERRY Installation And Operating Instructions Manual page 39

Step 11: Swing Wall Assembly
Part 2
Note: Pre-drill all holes using a 3/16" drill bit before installing the lag screws.
D: Attach (0369) Lower Diagonal to the end of (2157) Ground SW Side on the Front Wall side with 1 (H2) 1/4 x
2" Hex Bolt (with lock washer, flat washer and t-nut) and to (2153) Post with 1 (LS2) 1/4 x 2-1/2" Lag Screw (with
flat washer). (fig. 11.2)
E: Tight to the bottom of (2126) SW Floor and bevelled edges flush to outside edge of (2153) Posts, attach 1
(2113) Gussett II to each side using 2 (LS3) 1/4 x 3" Lag Screws (with flat washer) per gusset. (fig. 11.2)
Flush
Wood Parts
2 x Gusset II 5/4 x 4 x 18-1/2"
2113
1 x Lower Diagonal 2 x 3 x 37"
0369
Fig. 11.2
2153
2113
LS3
1/4" flat
washers
1/4" flat
washer
2157
1/4" flat
washer
1/4" lock
washer
1 x H2
4 x
LS3
1 x
LS2
1/4"
t-nut
H2
Hardware
1/4 x 2" Hex Bolt (1/4" lock washer, 1/4" flat washer, 1/4" t-nut)
1/4 x 3" Lag Screw (1/4" flat washer)
1/4 x 2-1/2" Lag Screw (1/4" flat washer)
39
2126
Flush
LS2
0369
Front Wall