Com 2 Port And Terminal Requirements - Cabletron Systems ETWMIM User Manual

REQUIREMENT/SPECIFICATIONS
Table 2-1. MMACs with Shunting Capabilities
MMAC Chassis
MMAC-3FNB
MMAC- 5FNB
MMAC-8FNB
MMAC-M8FNB DK000000000 or above
MMAC-M5FNB
MMAC-M3FNB

2.2 COM 2 PORT AND TERMINAL REQUIREMENTS

The COM 2 port supports a Digital Equipment Corporation VT200™ or
VT300™ series terminal (or emulation of one of these terminals). This
section lists the specifications for the front panel COM 2 port and the
necessary terminal requirements to access ETWMIM Local
Management.
An RJ-45 connector provides the interface to a management terminal.
The maximum COM 2 cable length is 50 feet. Figure 2-1 illustrates the
required pin configuration.
Page 2-2
Part #
FC000000000 or above
CC000000000 or above
CG000000000 or above
all
all