Table of Contents
Advertisement
INSTALLING THE ETWMIM
3.2 SETTING THE CONFIGURATION SWITCHES
The ETWMIM has two configuration switches — a switch bank, and
an Ethernet connection slide switch. You must set these switches
before installing the ETWMIM. Figure 3-1 illustrates the location of
these items on the ETWMIM board.
Ethernet Connection
Switch (SW 4)
Switch Bank (SW 2)
Page 3-2
Rear Panel
BackplaneConnection
Front Panel
EPIM Connection
Figure 3-1. Location of Switches
ETWMIM
Front Panel
ON
OFF
1 2 3 4 5 6 7 8
Refer to Table 3-1
For Settings.
Advertisement
Table of Contents
