Cabletron Systems ETWMIM User Manual page 2

NOTICE
Cabletron Systems reserves the right to make changes in specifications and other
information contained in this document without prior notice. The reader should in all
cases consult Cabletron Systems to determine whether any such changes have been
made.
The hardware, firmware, or software described in this manual is subject to change
without notice.
IN NO EVENT SHALL CABLETRON SYSTEMS BE LIABLE FOR ANY INCIDENTAL,
INDIRECT, SPECIAL, OR CONSEQUENTIAL DAMAGES WHATSOEVER
(INCLUDING BUT NOT LIMITED TO LOST PROFITS) ARISING OUT OF OR
RELATED TO THIS MANUAL OR THE INFORMATION CONTAINED IN IT, EVEN
IF CABLETRON SYSTEMS HAS BEEN ADVISED OF, KNOWN, OR SHOULD HAVE
KNOWN, THE POSSIBILITY OF SUCH DAMAGES.
CAUTION: THIS T1 CARD IS INTENDED TO BE INSTALLED IN CSA CERTIFIED/
UL LISTED EQUIPMENT BY A QUALIFIED SERVICE PERSON. CHECK THE
EQUIPMENT OPERATION/INSTALLATION INSTRUCTIONS AND/OR
EQUIPMENT MANUFACTURER TO VERIFY/CONFIRM YOUR EQUIPMENT IS
SUITABLE FOR INSTALLED APPLICATION CARDS.
CAUTION: ALWAYS DISCONNECT T1 BOARD (THE ONE WITH THE TELEPHONE
PLUG/JACK) FROM THE TELEPHONE SYSTEM WHEN INSTALLING OR WHEN
THE COVERS ARE REMOVED FROM THE HOST PRODUCT.
CAUTION: APPLY THE ENCLOSED ADHESIVE WARNING LABEL TO THE
OUTSIDE OR INSIDE OF THE EQUIPMENT ENCLOSURE ADJACENT TO THE T1
CARD.
© Copyright August 1994 by:
Cabletron Systems Inc.
P.O. Box 5005, Rochester, NH 03867-0505
All Rights Reserved
Printed in the United States of America
Order Number: 9030661-01 August, 1994
ETWMIM, MMAC, T1-SRM, EPIM-T, EPIM-X, EPIM-F1/F2, EPIM-F3, EPIM-C,
TPT-T, FOT-F, FOT-F3, and Flexible Network Bus are trademarks of Cabletron
Systems, Inc.
Spectrum, and LANVIEW are registered trademarks of Cabletron Systems, Inc.
IBM is aregistered trademark of International Business Machines Corporation.
VT200 and VT300 are trademarks of Digital Equipment Corporation.
Compuserve is a registered trademark of Compuserve, Inc.
Ethernet is a trademark of Xerox Corporation.
Printed on recycled paper
i