Cabletron Systems ETWMIM User Manual page 30

5. Insert the connector pins of the T1-SRM into the connector on the
ETWMIM mother board.
Caution: Make sure pins set properly in connector holes. Improper
connection can damage both the T1-SRM and the ETWMIM.
6. Press down on the back of the T1-SRM until the pins slide all the
way into the connector holes to ensure proper contact.
Note: Failure to make proper pin contact may result in poor network
performance, board malfunctions, or Local Management Configuration
Screen omissions.
7. Replace the lock-nuts and tighten them down with the nut-driver.
Connector
Pins
Connector
Figure 3-4. Installing the T1-SRM
INSTALLING THE ETWMIM
Lock-nut
ETWMIM
Page 3-7