Setting The Syncport Type Field; Setting Wan Physical Configuration Screen Fields; Setting The T1 Timeslot Configuration Table - Cabletron Systems ETWMIM User Manual

5.7.4 Setting the SyncPort Type Field

To set the SyncPort type:
1. Use the arrow keys to highlight the SyncPort Type field.
2. Press the Return key to toggle the selections.
3. After reaching the desired selection, use the arrow keys to
highlight the SAVE command.
4. Press the Return key. The message "SAVE DONE" appears and
Local Management saves the changes to memory.
5.7.5 Setting WAN Physical Configuration Screen Fields
To set a WAN Physical Configuration screen field:
1. Use the arrow keys to highlight the WAN Physical Configuration
screen field you want to change.
2. Press the Return key to toggle the selections.
3. When the desired selection appears, use the arrow keys to
highlight the SAVE command.
4. Press the Return key or press F6. The message "SAVE DONE!"
appears and Local Management saves the changes to memory.
5.7.6 Setting the T1 Timeslot Configuration Table
The T1 Timeslot Configuration Table allows you to configure how your
ETWMIM utilizes the T1 line. The configuration table consists of 24
Timeslots. You must assign each Timeslot an Interface number
(04-28, or 00 if the Timeslot is not used).
Note: The ETWMIM automatically assigns Interface 01 for Ethernet,
Interface 02 for Token Ring, and Interface 03 for the SYNC port.
When you lease an entire T1 line, you can use all 24 Timeslots (the full
T1 bandwidth). If you lease only a fraction of the T1, the service
provider will tell you which Timeslots to use.
LOCAL MANAGEMENT
Page 5-21