Installing The T1-Srm - Cabletron Systems ETWMIM User Manual

INSTALLING THE ETWMIM
3. Slide the EPIM into place, making sure the connectors on the rear
of the module and inside the ETWMIM attach properly.
4. Tighten the EPIM mounting screw.
Note: See Appendix A for EPIM specifications and cabling information.

3.5 INSTALLING THE T1-SRM

The ETWMIM allows for an optional T1-SRM. To install this optional
T1 interface you need the following tools:
• disposable static wrist strap (provided with your ETWMIM)
• 5/16" nut driver, or equivalent.
After obtaining the necessary equipment, refer to Figure 3-4 and
proceed as follows:
1. Using the nut driver, remove the T1 cover plate lock-nuts from the
inside of the ETWMIM faceplate.
2. Remove the T1 cover plate and save it in the event you want to
remove the T1-SRM at a later date.
3. Remove the T1-SRM from its protective package.
4. Attach the T1-SRM such that the holes on the ends of the device
slide over the bolts on the back of the ETWMIM faceplate. (See
Figure 3-4.)
Page 3-6
Figure 3-3. EPIM Replacement
Mounting Screw