Table of Contents
Advertisement
USING LANVIEW
4.1 SYSTEM STATUS LEDs
BOK (Board OK)
•
Flashing (three times/second) - Indicates that the module is
running a self-test. This LED flashes three times/second during
the self-test, and then adjusts to the normal one time/second
rate.
•
Flashing (one time/second) - Indicates that the module has
successfully completed its self-test and is ready for normal
operation.
ERR (Error)
•
On - Indicates the detection of a hardware failure. This LED
should not be on during normal operations. If the problem
persists, contact Cabletron Systems Technical Support.
•
Off - Indicates normal operating conditions.
4.2 ETHERNET STATUS LEDs
STBY (Standby)
Standby is an inactive state where the module is not passing data on
the station connection. Standby is set/reset via Local Management or
in-band network management.
•
On - Indicates that the module is in Standby mode.
•
Off - Indicates normal operation. The module is operational
and passing data on the Station port.
Page 4-2
Advertisement
Table of Contents
