Table of Contents
Advertisement
5.8.2 Configuring PPP Interfaces
The ETWMIM Local Management automatically assigns the next
available bridge port to interfaces. There are 30 Bridge Ports
available.
To configure an Interface Number:
1. Use the arrow keys to highlight the Interface Number field.
2. Press the Return key to select the Interface Number (02-26) you
want to configure.
Note: Before you configure an Interface Number to a Bridge Port, you
must first assign the Interface Number to a Timeslot. Refer to section
5.7.6, Setting the T1 Timeslot Configuration Table.
3. Use the arrow keys to highlight the Active Protocol field.
4. Press the Return key to select PPP or NONE.
•
Select PPP to assign a Bridge Port
•
Select NONE to remove a previously assigned Bridge Port
5. Use the arrow keys to highlight the SAVE command.
6. Press the Return key or press F6. The message "SAVE DONE!"
appears. The ETWMIM Local Management automatically assigns
an Active Port Number (PT#) to the Interface number (IF#) and the
changes are saved to memory.
LOCAL MANAGEMENT
Page 5-27
Advertisement
Table of Contents
