Table of Contents
Advertisement
USING LANVIEW
4.3 TOKEN RING STATUS LEDs
STBY (Standby)
Standby is an inactive state where the module is not passing data on
the ring. Standby is set/reset via in-band network management.
•
On - Indicates that the module is in Standby mode.
•
Off - Indicates normal operation. The module is operational
and passing data on the Station port.
16 Mbps (Ring Speed)
•
On - Indicates that the module ring speed is set to 16 Mbps.
•
Off - Indicates that the module ring speed is set to 4 Mbps.
LWRP (FNB Left Wrap)
The LWRP LED indicates the state of the FNB left (trunk) connection.
•
On - Indicates that the left FNB ring connection has been set
to the wrap state by network management.
•
Off - Indicates normal operation. The FNB left connection is in
a non-wrap state. When this LED is on, it indicates that the left
FNB ring connection has been set to the wrap state by network
management.
NSRT (Insert)
•
On - Indicates that the module is inserted onto the ring via its
FNB Trunk connection. This is the normal operating condition.
•
Off - Indicates that the module has been removed from the
ring.
Page 4-4
Advertisement
Table of Contents
