Table of Contents
Advertisement
SMA 905 Connectors
F2
Figure A-8. The EPIM-F1, EPIM-F2 and EPIM-F3
3. Attach the fiber labeled 2 to the applicable transmit port labeled
TX, on the module.
4. At the other end of the fiber optic cable, attach the fiber labeled 1
to the transmit port of the device.
5. Attach the fiber labeled 2 to the receive port.
6. Check that the EPIM's LNK LED is on. If the LED is not on,
perform the following steps until it is:
a. Check that the power is turned on for the device at the other
end of the link.
EPIM SPECIFICATIONS
F1
SMA 906 Connectors w/
Half Alignment Sleeves
ST Connectors
F3
ST Connectors
Page A-17
Advertisement
Table of Contents
