Table of Contents
Advertisement
EPIM SPECIFICATIONS
Parameter
TX Power:
TX Budget:
RX Sensitivity:
MAX Receive
Power:
Bit Error Rate:
Note: The above transmitter power levels and receive sensitivity levels
represent Peak Power Levels after optical overshoot. You must use a
Peak Power Meter to correctly compare the above values to those you
measure on any particular port. If you measure Power Levels with an
Average Power Meter, you must subtract 3 dBm from the measurement
to correctly compare those measured values to the values listed above
(e.g., -29.5 dBm peak = -32.5 dBm average).
Page A-10
Typical
-15.1 dBm
14.4 dBm
-29.5 dBm
-6.99 dBm
-10
Better than 10
Advertisement
Table of Contents
