Removing The Existing Dram Simm - Enterasys MATRIX 7H4385-49 Hardware Installation Manual

Gaining Access to Memory Modules
2. Remove the two screws fastening the NEM to the DFE module front panel and
remove the standoff fastening the NEM to the main board. Save the two screws and
standoff for later use to reinstall the NEM.
3. Lift and remove the NEM off the two main PC board connectors. Now you have
access to the DRAM SIMM. To replace the DRAM SIMM, proceed to "Removing the
DRAM SIMM".
Removing the DRAM SIMM
To remove the DRAM SIMM, refer to Figure
1. Refer to Figure
from the connector.
2. Remove the DRAM SIMM from the connector.
Figure B-5
1 Connector arms
B-8 Mode Switch Settings and Option Installations
B‐5. Push the connector arms away from the DRAM SIMM to release it
Note: The ejector arms on this connector are not spring-loaded, so they will remain in the
open position until manually closed.

Removing the Existing DRAM SIMM

À
2 Memory module
B‐5 and proceed as follows.
Á
Â
À
3 Connector