Dram Simm Replacement Procedure For 4G4202-60 Or 4G4282-41; Removing Existing Dram Simm From 4G4202-60 Or 4G4282-41 - Enterasys Matrix DFE-Gold 4G4202-60 Hardware Installation Manual

Memory Locations and Replacement Procedures

DRAM SIMM Replacement Procedure for 4G4202-60 or 4G4282-41

The DRAM SIMM is considered a field replaceable unit on both the 4G4202‐60 and
4G4282‐41.
Removing the DRAM SIMM
To remove the existing DRAM SIMM, proceed as follows:
1. Locate the DRAM SIMM connector on the main PC board. Refer back to Figure
2. Push the connector arms away from the DRAM SIMM, as shown in Figure
enough to release the DRAM SIMM from the connector contacts.
Figure B-4
➀
Connector arms
3. Pull the DRAM SIMM straight up and remove it from the connector contacts.
B-8 Mode Switch Bank Settings and Optional Installations
Caution: Observe all Electrostatic Discharge (ESD) precautions when handling sensitive
electronic equipment.
Precaución: Al trabajar con equipos electrónicos sensibles, tome todas las precauciones
de seguridad para evitar descargas de electricidad estática.

Removing Existing DRAM SIMM from 4G4202-60 or 4G4282-41

À
Á
Â
➁
DRAM SIMM
B‐4,
À
➂
Connector contacts
B‐3.