Memory Locations And Replacement Procedures; Location Of Dram Simm And Dimm Memory Modules; Mode Switch Location On 4G4202-60 And 4G4282-41 - Enterasys Matrix DFE-Gold 4G4202-60 Hardware Installation Manual

Memory Locations and Replacement Procedures

Figure B-1

Mode Switch Location on 4G4202-60 and 4G4282-41

➀
1 2 3 4 5 6 7 8
ON
➀
Mode switch pack
Memory Locations and Replacement Procedures
In the event that the Dual In‐line Memory Module (DIMM) or DRAM Single In‐line
Memory Module (SIMM) (FLASH memory) needs to be replaced, the following sections
describe how to access, locate and replace these memory modules. If you have questions
concerning the replacement of either memory module, refer to "Getting Help" on
page xviii for details on how to contact Enterasys Networks.

Location of DRAM SIMM and DIMM Memory Modules

Figure B‐2 and Figure B‐3 show the locations of the DRAM SIMM and DIMM on the each
main board of the 4G4202‐60 and the 4G4282‐41, respectively.
Matrix DFE-Gold Series Modules Hardware Installation Guide B-3