2
Setting Up
Installing a Valve-based Sampling System
3 Connect the flow cell to the pump, see
4 Connect the valve unit to the flow cell. Connect the 1.4 m or 2.2 m tubing
To minimize carry over, use the 1.4 m tubing.
N O T E
5 Connect pump to waste. Insert the conical adapter into the pump tubing on
Replacing Tubing
General instructions for attaching new fittings to tubing are provided in a
replacement PTFE tubing kit (part number 5041-2191). This kit contains 10 m
of PTFE tubing.
50
0.5 m tubing with the short cell fitting to the outlet of the flow cell, and
insert the conical adapter into the pump tubing on the inlet side of the
pump.
with the long cell fitting to the inlet (marked with
Connect the valve fitting to the valve outlet.
the outlet side of the pump and put the transparent fitting into a waste
beaker.
Agilent 8453 Dissolution Testing System Installing and Operating Manual
Figure 6
on page 32. Connect the
↓
) of the flow cell.