2
Setting Up
Installing a Valve-based Sampling System
Connecting Cables
Check you have the cables shown in
Table 12
From Controller:
Power socket
GPIO-to-controller
Controller-to-Valve 1
Controller-to-Pump 1
The cables connect to the rear panels of the valve-pump controller, valve unit,
pump and spectrophotometer.
GPIO-to-controller cable
Pump
Spectrophotometer
GPIO-to-controller cable
Figure 14
The valve-pump controller can control up to four valve units and pumps. You
connect the valve unit and its pump to channel 1.
44
Cables for Valve Unit and Controller
Connecting Cables
Agilent 8453 Dissolution Testing System Installing and Operating Manual
Table
12.
To Connector:
Line-power source
Agilent 8453 spectrophotometer
Valve unit
Peristaltic pump
Remote
50-60 Hz
90 VAmax.
Manual Advance
Remote/Manual
Controle
Controller
Valve unit