Agilent Technologies 8453 User Manual, Installing And Operating Manual page 76

3 Using the Peristaltic Pumps 1VS and 8VS
Maintaining Your Pump
1 Remove the tubing cassettes, see
2 See
Figure 31
3 Pull the pressure-wheel assembly from the front mounting.
Replacing the Pressure-wheel Assembly
1 Place the pressure-wheel assembly on the front mounting. You may need to
2 Screw the three screws through the pressure-wheel assembly to the front of
76
page 75.
Figure 31 for the position of the screw holes to aid in locating the
screws. Using a 3 mm hex key, unscrew the three screws holding the
pressure-wheel assembly to the front of the pump.
Pump with the Pressure-Wheel Assembly Removed
use a flat-tip screwdriver to turn the drive shaft of the pressure-wheel
assembly to align it with the flange in the front of the power housing.
the pump, using a 3 mm hex key.
Agilent 8453 Dissolution Testing System Installing and Operating Manual
"Removing the Tubing Cassette" on