Replacing 6000A Assemblies - Agilent Technologies 6000 Series Service Manual

Agilent 6000 Series Oscilloscopes
Service Guide
5

Replacing 6000A Assemblies

To remove the cabinet
To remove the handle 95
To remove the storage lid
To remove the front panel assembly
To remove the keyboard assembly
To remove the display assembly
To remove the display assembly
To remove the backlight inverter board and e-field shield
To remove the LCD, gasket, and protective lens from the display
mount 111
To remove the power supply shield
To remove the power supply
To remove the power shaft
To remove the AC input board
To remove the batteries (Option BAT only)
To remove the battery controller board (Option BAT only)
To remove the fan 125
To remove the system board
This chapter describes how to remove assemblies from the
Agilent 6000A Series Oscilloscopes. After you have removed an
assembly, to install the replacement assembly, follow the
instructions in reverse order.
The parts shown in the following figures are representative and
may look different than what you have in your oscilloscope.
Agilent Technologies
94
96
97
100
103
103
114
118
119
120
121
127
107
123
91