Connecting Cables - Agilent Technologies 8453 User Manual, Installing And Operating Manual

2 Setting Up
Installing Your Multibath System

Connecting Cables

Check you have the cables shown in
Table 16
From Controller:
Power socket
GPIO-to-controller
Controller-to-Valve 1 through 4
Controller-to-Pump 1 through 4
The cables connect to the rear panels of the valve-pump controller, valve units,
pumps and spectrophotometer.
GPIO-to-controller cable
Spectrophotometer
GPIO-to-controller cable
Figure 24
The valve-pump controller can control up to four valve units and pumps. You
connect the valve unit and its pump to the same channel.
60
Cables for Valve Unit and Controller
Connecting Cables
Agilent 8453 Dissolution Testing System Installing and Operating Manual
Table 12.
To Connector:
Line-power source
Agilent 8453 spectrophotometer
Valve units
Peristaltic pumps
50-60 Hz
90 VAmax.
Manual Advance
Remote/Manual
Controle
Remote
Pump
Controller
Valve unit