S-COM 6K Owner's Manual page 176

Enable/Disable End-of-Transmission
Allows commands to be terminated by ending the transmission
(releasing user PTT). This is in addition to the usual (*) character.
· The (*) character will terminate a command in any case.
· You may enable or disable this feature separately for each receiver.
· If this feature is enabled, the command will be executed 0.25 seconds after
the transmission ends.
· Enter one digit, 0 for OFF (disabled), 1 for ON (enabled).
Command Form:
Command
Enable/Disable End-of-Transmission
Command Execution for RX1
Enable/Disable End-of-Transmission
Command Execution for RX2
Acknowledgment: Sends OK
Errors:
Error
? err 1
? err 2
Default condition: End-of-Transmission Command Execution is OFF
(disabled) for all receivers; (*) character required to terminate all commands
NOTE: These commands replace the old "(PW) 56" and "(PW)
99" commands.
Examples:
Whether or not this feature is enabled, the (*) character will always terminate a
command. This is particularly useful if an input signal keeps the receiver active
after a user enters a DTMF command.
If the feature is enabled, users can simply enter a command and release the
push-to-talk button instead of entering the trailing (*). The 0.25-second delay
prevents a partial command from being accidentally executed if the user's
signal momentarily drops.
6K V2.0 12-14-01
Command Execution
175
Form
(PW) 63 57 x *
(PW) 63 58 x *
Meaning
wrong number of digits entered
illegal digit entered
Data Digit
0 = OFF (disabled)
1 = ON (enabled)
0 = OFF (disabled)
1 = ON (enabled)