S-COM 6K Owner's Manual page 145

COMMAND TERMINATION FOR CONTROL RECEIVER
Command Form:
Description:
Acknowledgement: OK
Errors:
? ERR 1
Default Condition:
Examples:
6K V1.02 03-16-91
(PW) 56 (00 = */0.1 - 9.9 sec) *
This command allows users to terminate commands entered via the control
receiver (RX2) by releasing the PTT button (COR drop). If not allowed, then
the star "*" character is required to terminate a command. Whether or not
the carrier drop method is enabled, the * character can always be used to
terminate a command.
If the COR drop method is desired, enter two data digits in the range 01 to
99, representing 0.1 - 9.9 seconds. This is the amount of time after COR
drop is sensed that the command will be executed. To disable the COR
drop method, thereby requiring the * character for command termination,
enter two zeros (00).
wrong number of digits entered
* character required to terminate all commands.
To turn on the carrier-drop termination feature and set the delay to 1.0
seconds, enter:
(PW) 56 10 *
Remember, the * character can still be used to terminate a command. This
is important if weak signals are holding up the COR.
Some delay is needed for this feature to work properly; without it, a
momentary loss of carrier could terminate a command before it's completely
entered. But delays greater than a few seconds are not practical, because
the incoming command must be terminated before the DTMF Interdigit Timer
expires. And, since some user transmitters don't drop quickly after the last
DTMF character, more time elapses before the carrier drops.
UTILITIES
144