S-COM 6K Owner's Manual page 106

MUTE ON/OFF
Command Form:
Description:
Acknowledgement: OK
Errors:
? ERR 1
Default Condition:
Examples:
6K V1.02 03-16-91
DTMF DECODER
(PW) 63 03 (0 = disable/1 = enable) *
This command turns ON or OFF the controller's ability to mute DTMF tones
from the repeater receiver.
wrong number of digits entered
? ERR 2 illegal digit entered
ON (enabled)
Muting is usually left ON (enabled) to prevent DTMF digits from being
repeated, and to prevent listeners from learning macro and command
codes. Sometime it is necessary to signal devices through the repeater, and
during these occasions the muting may be turned OFF (disabled).
To turn OFF (disable) the muting of DTMF tones, enter the following
command:
(PW) 63 03 0 *
105