S-COM 6K Owner's Manual page 105

MUTE DELAY
Command Form:
Description:
Acknowledgement: OK
Errors:
? ERR 1
Default Condition:
Examples:
6K V1.02 03-16-91
DTMF DECODER
(PW) 96 (0-9) *
This command selects the duration of the muting that occurs after a DTMF
digit is received by the controller. Enter one data digit representing the delay
duration .0 through .9 seconds.
wrong number of digits entered
? ERR 2 illegal digit entered
0.5 seconds
When the controller recognizes a DTMF digit, it mutes the audio so that the
digit is not retransmitted. (Since some time is required by the controller to
decode the digit, a short burst of tone is retransmitted). A timer is started for
the purpose of delaying the unmuting. This allows a string of DTMF digits to
be entered, with all but the first one fully muted. The command shown
above controls this timer. If set to 0 (zero), the muting will end when the
DTMF digit is released. If set to 9, the muting will last 0.9 seconds beyond
the release of the DTMF digit. Since a voice will occasionally trip the DTMF
decoder, a long mute delay may not be desired.
If a DTMF digit is held down for a continuous period of time, the controller
will stop muting after 10 seconds.
To change the mute delay to 0.3 seconds, enter the following command:
(PW) 96 3 *
104