S-COM 6K Owner's Manual page 132

ASSIGN PRIVILEGE LEVEL
Command Form:
Description:
Acknowledgement: OK
Errors:
? ERR 1
Default Condition:
Examples:
6K V1.02 03-16-91
SECURITY
(PW) 94 (root no., level) *
This command assigns a privilege level to a control command.
Enter the root number of the command, then 0 or 1:
0 = Command may be used by either password
1 = Command may be used only by the Master password
wrong number of digits entered
? ERR 2 illegal digit entered
all commands may be accessed by either password
Assume the Control Operators have full privileges, the default condition. To
prevent control operators from changing either the Master password or the
Control Op password, enter the following:
(PW) 94 92 1 *
[Root 92 is the Control Op password command.]
(PW) 94 93 1 *
[Root 93 is the Master password command.]
The Privilege Level command allows Control Operators limited access to
repeater functions. The password may be changed as often as desired.
131