PAUSE
Command Form:
Description:
Acknowledgement: none
Errors:
? ERR 1
Default Condition:
Examples:
6K V1.02 03-16-91
(PW) 98 (1 - 255 seconds) *
This command causes the controller to stop the execution of the commands
that follow for the programmed amount of time. This causes a delay to
occur between commands.
wrong number of digits entered
? ERR 2
illegal digit entered
no pause
To delay command execution 2 seconds, enter:
(PW) 98 2 *
To delay command execution 10 seconds, enter:
(PW) 98 10 *
Very long delays are not recommended, as the controller will not execute
additional DTMF commands that it receives during the delay. However,
pause commands can be used very effectively when placed into macros
between other commands.
UTILITIES
145