Table of Contents
Advertisement
INSTALLATION
1.
INTRODUCTION
You will need to prepare either one or two cables for your 6K controller. One cable is for DC power,
and is terminated with the 2.5 mm power plug provided. Since DC power may be supplied to the
6K via the other cable if desired, this first cable is optional. The 2.5 mm power jack is retained in
the 6K for the benefit of customers who are upgrading from existing 5K installations.
The other cable is for repeater connections, logic inputs and outputs, and so on. It is terminated
with the DB25P 25-pin plug provided.
This section of the manual describes the proper connections to be made between your controller
and your repeater equipment. It also describes the proper way to make the necessary audio level
adjustment.
10
6K V1.02 03-16-91
Advertisement
Table of Contents
