Siemens SIMATIC NET SCALANCE SC-600 Configuration Manual page 141

• Filename
A file name is preset here for every file type.
Note
Changing the file name
You can change the file name preset in this column. After loading on the device, the
changed file name can also be used with the Command Line Interface.
• Actions
Select the action from the drop-down list. The selection depends on the selected file
type, for example, the log file can only be saved.
The following actions are possible:
– Save file
– Load file
Procedure
Loading or saving data using TFTP
1. Enter the address of the TFTP server in "TFTP server address".
2. Enter the port of the TFTP server to be used in "TFTP Server Port".
3. If applicable, enter the name of a file in which you want to save the data or take the
data from in "Filename".
Note
Files whose access is password protected
To be able to load these files on the device successfully, you need to enter the
password specified for the file in "System" > "Load&Save" > "Passwords".
4. Select the action you want to execute from the "Actions" drop-down list.
5. Click "Set Values" to start the selected action.
6. If a restart is necessary, a message to this effect will be output. Click the "OK" button to
run the restart. If you click the "Abort" button, there is no device restart. The changes
only take effect after a restart.
Reusing configuration data
If several identical devices are to receive the same configuration and the IP addresses
are assigned using DHCP, the effort for reconfiguration can be reduced by saving and
reading in the configuration data.
SCALANCE SC-600 Web Based Management (WBM)
Configuration Manual, 10/2021, C79000-G8976-C475-03
With this selection, you save a file on the TFTP server.
With this selection, you load a file from the TFTP server.
Configuring with Web Based Management
4.4 "System" menu
141