Siemens SIMATIC NET SCALANCE SC-600 Configuration Manual page 275

Description of the displayed values
The page contains the following boxes:
• VRRPv3
Enable or disable routing using VRRPv3.
• Reply to pings on virtual interfaces
When enabled, the virtual IPv addresses also reply to the ping.
• VRID-Tracking
Enable or disable VRID tracking.
When enabled, all VRRP instances are monitored. If the status of a VRRP instance
changes to "Initialize", the priority of all VRRP instances is reduced to the value "1".
If the status of the VRRP instance changes, the original priority of all VRRP instances
is restored.
• Interface
Select the VLAN Interface that functions as the virtual router from the drop-down list.
• VRID
Enter the ID of the virtual router in the input box. This ID defines the group of routers
that form a virtual router (VR). In the group, this is the same. It can no longer be used
for other groups.
Valid values are 1.. 255.
The table has the following columns:
• Select
Select the row you want to delete.
• Interface
Shows the interface that functions as the virtual router.
• VRID
Shows the ID of the virtual router.
• Virtual MAC Address
Shows the virtual MAC address of the virtual router.
• Primary IP Address
Shows the numerically lowest IPv4 address in this VLAN. The entry 0.0.0.0 means that
the "Primary" address on this VLAN is used. Otherwise, all IPv4 addresses configured
on this VLAN in the "Layer 3 > Subnets" menu are valid values.
SCALANCE SC-600 Web Based Management (WBM)
Configuration Manual, 10/2021, C79000-G8976-C475-03
Configuring with Web Based Management
4.6 "Layer 3" menu
275