Operation; Test Setup With Autowave; Cabeling With Autowave; Test Setup And Cabeling With Netwave And Amp200N Series - Ametek AMP 200N Manual For Operation

AMETEK CTS
6

Operation

The AMP 200N needs an AutoWave generator or a Netwave for operate. The AutoWave/Netwave generator
controls the AMP 200N via the framebus. The user needs the autowave.control or Netwave.controlsoftware
for operate the system with the AMP200N.
6.1

Test Setup with Autowave

The typical test setup with the control cable connections is illustrate in figure 4.1
For operation with AMP200N the software
AutoWave.control is necessary. For device control the
following interfaces must be used:
Devices
AutoWave AMP200N
AutoWave AMP200N VDS200x
NOTE: If the user has a device which needs GPIB,
(example VDS200x), it is mandatory to use
the GPIB interface.
6.1.1

Cabeling with Autowave

The general cabling with AMP 200N is
illustrated in Figure 3.2.
There are many applications that use an
AMP200N. Please refer
description in the specific standards.
Chapter Applications shows a selection test
setup and their specific software settings for
different tests.
List of cable connections:
Computer to...
AutoWave
AutoWave & VDS200x
AutoWave to AMP 200N
Framebus OUT Framebus IN
CH 1 CH 1 IN
CH 2 CH 2 IN
AMP 200N to VDS 200x
Signal OUT 0-10V
AMP 200N
Framebus OUT Termination
6.2

Test Setup and cabeling with Netwave and AMP200N Series

The typical test setup with the control cable connections is illustrate in figure 4.3
Manual for Operation
GPIB Ethernet
X X
X
to the setup
GPIB / IEEE488
Ethernet
GPIB / IEEE488
Sub-D 15 poles
BNC
BNC
BNC
Sub-D 15 poles
V 4.0.3
Figure 8 General Test setup with AMP 200N and AutoWave
Figure 9 System cabling using AMP 200N
AMP 200N series
19 / 60