Technical Data Amp200N1.1; Amplifier Output Characteristics; Signal Generator Output Characteristics (Built In); Measurements (Optional) - Ametek AMP 200N Manual For Operation

AMETEK CTS
9

Technical data AMP200N1.1

9.1

Amplifier output characteristics

Frequency range
Signal power
Power dissipation amplifier
Output voltage
Output current
DC current (for magnetic field tests)
Harmonic Distortion (THD)
Output Impedance
Current protection
Overtemperature protection
9.2

Signal generator output characteristics (built in)

Frequency range
Output voltage
Dc offset
9.3

Measurements (optional)

Measuring Unit AMP 200N
Frequency range
Accuracy
Current measurement
Voltage measurement
Magnetic field
9.4

General

Dimension
Weight
Supply voltage
Input power
Inrush current (power ON)
Fuses
Cooling
Temperature
Humidity
Manual for Operation
DC – 500kHz
800 W (nominal)
800 W (maximum)
HIGH range: 50 V rms, max. ± 70 V peak up to 100 kHz
30 V rms, max. ± 42 V peak 100 kHz to 250 kHz
LOW range: 25 V rms, max. ± 35 V peak up to 100 kHz
15 V rms, max. ± 21 V peak 100 kHz to 250 kHz
HIGH range: Max 8.0 A rms
LOW range: Max. 16.0 A rms
25 A
< 0.1%
30 mΩ @1 kHz
Short circuit protected
integrated into amplifier
DC, 10 – 250 kHz (sinusoidal)
±10 V
±10 V, programmable, to control external DC amplifier
Frequency-selective instrument for voltage, current and magnetic field
10 Hz – 250 kHz
Better than 5%
External with current clamp
Range 100 mV/A:
Range 10 mV/A:
17 mV – 70 V rms
Use voltage input for loop sensor measuring
19", 6 HU (500mm x 449mm x 267mm)
36.1kg
115 V +10/-2%, 50/60 Hz or (min 112 V)
230 V +10/-15%, 50/60 Hz
Max. 1000 W
60 A pk-pk
AMP 200N1.1 115 V: 16 AT,
Active cooling, air ventilation
10°C - 40°C
20 to 85% relative humidity (RH non condensing)
V 4.0.3
1 mA – 30 A rms
10 mA – 300 A rms
230 V: 10 AT
AMP 200N series
25 / 60