Ametek AMP 200N Manual For Operation page 42

AMETEK CTS
Test characteristics for CI 210
Method:
Coupling Method :
Test Regulation Method:
Disturbance Current limit : yes/no
Diagram Unit
Tolerances
Tolerances :
Additional Settings (Closed Loop with Scope only)
Level Change at next Testpoint:
Couplings
Coupling Type
Coupling Device
User Software settings (Closed Loop with Scope only)
The user has to complete the test settings with his individual used measuring devices.
New measuring instruments can be installed through the Setup Menu in Mainwindow of Auoewave.control or by
clicking the setup button in the Voltage Measuring panel by the user.
A: Voltage Measuring Instrument: CH1
Measurement Instrument
Scope
Instrument Value
B: Measuring Equipment (voltage probe):
Equipment Type:
Equipment:
The 200mV pk-pk voltage ripple signal at the test start needs a signal of only 33mVpk-pk in the
signal generator (range ± 10V). Additional the VDS200 noise is specified as < 0.2V pk-pk.
Therefore low signals will have a noise ripple who loock very high.
Remark
Manual for Operation
Conducted
Voltage Level ( Closed Loop)
setted value
X-Axis : kHz ; Log
Y-Axis: Vpp ; linear
positive +10%
negative -0%
0dB
none (direct)
none
Measuring AC voltage ( pk-pk)
Mandatory in Ford EMC-CS 2009 standard
Voltage Peak To Peak
Voltage Probe
LeCroy HFP 2500
Example Closed Loop
10:1
V 4.0.3
AMP 200N series
42 / 60