Technical Data Amp200N; Amplifier Output Characteristics; Signal Generator Output Characteristics (Built In); Measurements (Optional) - Ametek AMP 200N Manual For Operation

AMETEK CTS
8

Technical data AMP200N

8.1

Amplifier output characteristics

Frequency range
Signal power
Power dissipation amplifier
Output voltage
Output current
Harmonic Distortion (THD)
Output Impedance
Current protection
Overtemperature protection
8.2

Signal generator output characteristics (built in)

Frequency range
Output voltage
Dc offset
8.3

Measurements (optional)

Measuring Unit AMP 200N
Frequency range
Accuracy
Current measurement
Voltage measurement
Magnetic field
8.4

General

Dimension
Weight
Supply voltage
Input power
Inrush current (power ON)
Fuses
Cooling
Temperature
Humidity
Manual for Operation
DC – 250 kHz
250 W (nominal)
250 W (maximum)
HIGH range: 50 V rms, max. ± 70V peak up to 100 kHz
30 V rms, max. ± 42V peak 100 kHz to 250 kHz
LOW range: 25 V rms, max. ± 35V peak up to 100 kHz
15 V rms, max. ± 21V peak 100 kHz to 250 kHz
HIGH range: Max. 2.5 A rms
LOW range: Max. 5.0 A rms
< 0.1%
30 mΩ @1 kHz
Short circuit protected
integrated into amplifier
DC, 10 – 250 kHz (sinusoidal)
±10 V
±10 V, programmable, to control external DC amplifier
Frequency-selective instrument for voltage, current and magnetic field
10 Hz – 250 kHz
Better than 5%
External with current clamp
Range 100 mV/A:
Range 10 mV/A:
17 mV – 70 V rms
Use voltage input for loop senso measuringr
19", 3 HU (500mm x 449mm x 133mm)
18.3 kg
115 V +10/-2%, 50/60 Hz or
230 V +10/-15%, 50/60 Hz
Max. 500 W
60 A pk-pk
2 x 6 AT (115V) 2 x 3.15 AT (230V)
Active cooling, air ventilation
10°C - 40°C
20 to 85% relative humidity (RH non condensing)
V 4.0.3
1 mA – 30 A rms
10 mA – 300 A rms
AMP 200N series
24 / 60