Accessories; Frame Bus Termination; Options - Ametek AMP 200N Manual For Operation

AMETEK CTS
3.2

Accessories

3.2.1

Frame Bus Termination

•
Frame Bus terminating for matching the end of the framebus. The
framebus, an internal bus system, is used for control EM Test
devices and work as daisy chain between the equipment. Longer
bus systems must be terminated with a Frame bus termination.
3.3

Options

•
Measuring Module
2 Channel Measuring module for frequency selected voltage and current
measuring
•
User software " AutoWave.control "
- Test, analysis and documentation with windows
- License version for testing according the most industrial standards
- Report generator with export function to word-processing software
•
CN 200N Series
Transformer assembly
•
Radiating Loop and Loop Sensor
- Radiating loop as per MIL –STD 461-E 120mm, 20 turns
RL_120:
- cable 3m with banana plugs
- Loop sensor as per MIL –STD 461-E 40mm, 51 turns
LS_040:
- cable 3m with BNC / speakon plugs
•
MN-HField matching resistor
for attenuate the antenna current for reduce the H-field strength.
With the short circuit bridge the user short the internal resistor for full output
current to the Antenna.
Switch position = 1(short circuit) for levels > 1A/m
•
C-Box H-Field (AMP 200N2 Only)
For magnetic immunity testing using select Helmholtz coils, an optional C-
Box H-Field is available. This is a capacitor box with selectable capacitance
values used to adjust the resonance point with supported coil can be driven in
resonance to achieve high field strengths. Compatible with HCS_50/28_B
Helmholtz coil for level ISO 11452-8 Level I - IV External and Level I - III
Internal. When this coil is chosen, a dialog to use the C-Box H-Field is
provided. autowave.control will prompt the user to select the appropriate
range on the C-Box.
Manual for Operation V 4.0.3
AMP 200N series
10 / 60