Operation 200-Series 19" Units Using Front Panel Control; Manual Operation; Main Menu; Service - Ametek 200 Series Quick Start Manual And Safety Instructions

AMETEK CTS
5.

Operation 200-series 19" units using front panel control

Most simulators are operated by an easy menu control system. Seven
function keys are available to select parameters and functions. All functions
are indicated on the display; max. 8 lines and 40 characters.
The selected parameter is blinking and can be changed by turning the knob (incr./decr.).
 : The digit to be changed can be selected with the cursor ().
- Setted values are direct indicated on the screen.
- Status on the bottom lines shows the desired status after pressing the function key.
ESC : ESC will take you back to the previous level in the menu and set the displayed values. The latest settings
are stored automatically and will be recalled when the menu is selected again.
EXIT :
The firmware will reset to the main screen.
UCS 200N
Automotive Transient Generator
V 1.04a16 SWN : 031016
5.1.

Manual Operation

5.1.1.

Main Menu

The main menu is where pulses are selected, and will vary by generator. Here you can also select the Service
menu.
MAIN MENU
F1 : Pulse 1
F2 : Pulse 2
F3 : Pulse 3a / 3b
F7 : Service
F1 F2 F3
5.1.2.

Service

SERVICE
F1 : Addresses
F2 : Selftest
F3 : Setup
F4 : Set default values
F1 F2 F3
F1 Addresses
Here you will find addreses for service and support
organizations
www.emtest.com
F2 Selftest
Together with the user the firmware can test some parts of the equipment. The software will clearly explain the self-
test procedure.
Micro Pulses 1, 2
Burst Pulses 3a, 3b
Freestyle
F4 : Freestyle
F5 : External
F6 : Standards
F4 F5 F6
F4 F5 F6
The generator type, serial number and the version
number SWN are shown on the main screen. These
numbers are listed in the test reports and calibration
certificates.
F7
F7
1.00
Automotive Transient Immunity Testing
20 / 26