Maintenance Mode - Mcube CubeScan BioCon-500 Service Manual

Service Manual for BioCon-500

7. Maintenance Mode

Maintenance mode can be used to adjust the system variables before the shipment. Set-
up of those variables follows the procedure below.
No.
Check ID OK!!!
Erase Sector OK!!!
Blank Check OK!!!
1
Program OK!!!
Verify OK!!!
Programming is completed!!!
2
3
Mcube Technology Co., Ltd.
www.mcubetech.co.kr
TM
LCD Screen Manipulation
To enter the Maintenance mode, push
LEFT key with ENTER key being
pushed and then push PRINT key after
the system is turned on and the initial
screen is displayed in normal mode. At
this time, the information as left is
displayed on the screen.
Turn off the system and again turn it on
to have the checkers as shown left on
LCD.
When the system is
maintenance mode,
"MAINTENANCE MODE"
displayed on the lower part of the
screen as left.
booted in
the message
will be
50