Assembling Of The Upper Case - Mcube CubeScan BioCon-500 Service Manual

Service Manual for BioCon-500

3.1.2 Assembling of the Upper Case

The assembling of the upper board takes the following steps, and the steps are
reversed for the dissembling.
Step
Attach the ⑤Direction Button, the ⑥PWR button, and the ⑦
1
PRINT/SCAN Button to the ④Key Board.
Attach the ④Key Board assembled in step 1 to the rear lower of
2
the ①Upper Case by using the ⑩M3 washer bolts.
Attach the ③LCD Module to the rear center of the ①Upper
3
Case by using the ⑨M3 washer bolts.
Insert the ②PRINT Module to the grooves of front upper, then
attach it by using lever lock as below
4
Remove the adhesive paper from the rear of the ⑧LCD Window,
5
then attach in the front center of the ①Upper Case.
Connect the ③LCD Module and the ④Key Board by using the
6
⑭LCD GND Cables and the fixing holes of them.
Connect the ⑮Key Board GND Cable to the fixing holes in lower
7
of the ④Key Board.
Connect the ⑪Printer Cable to the ②PRINT Module.
8
Connect the ⑫Key Board Cable to the ④Key Board.
9
Connect the ⑬LED Cable to the ④Key Board.
10
The picture of the Upper Case assembled is as below.
Mcube Technology Co., Ltd.
www.mcubetech.co.kr
TM
Description
(The Picture of the Upper Case Assembled)
Remark
⑧ X 6EA
⑨ X 4EA
⑭ X 2EA
⑮ X 2EA
⑪ X 1SET
⑫ X 1EA
⑬ X 1EA
26