Assembling Of The Ultrasonic Probe Module - Mcube CubeScan BioCon-500 Service Manual

Service Manual for BioCon-500
The components constituting the Ultrasonic Probe Module are as below.
No.
①
②
③
④
⑤
3.4.2 Assembling of Ultrasonic Probe Module
The assembling of the ultrasonic probe module takes the following steps. And the
steps are reversed for the disassembling.
Step
Connect signal line (A and B) into housing by wire color in the right
1
direction. Show in a picture of the previous page
Attach the ②Probe Cable to the ①Probe by using the ⑤Ranch
2
Bolt.
Attach the ③Button Sheet where the button is located
3
Attach the ④S/N Sheet to the opposite side of the ③Button Sheet
4
The picture of the Ultrasonic Probe Module assembled is as below.
Mcube Technology Co., Ltd.
www.mcubetech.co.kr
TM
Name
Probe
Probe Cable
Button Sheet
S/N Sheet
Ranch Bolt M3 20mm
Description
(The Picture of the Assembled Ultrasonic Probe)
Material Q' TY
1EA
1EA
PC 1EA
PC 1EA
STEEL 2EA
Remark
33